Avago-technologies Cache Protection for RAID Controller Cards Manuel d'utilisateur télécharger pdf (Page 110)

Avago Technologies

- 110 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide

May 2015

Chapter 2: Installing the Cache Backup Products

Attaching the CVFM04 Module to the RAID Controller and by Cable to a CVPM02 Module on

a Remote Mount Board

2.11.2.6 Reinstalling the RAID Controller on the Motherboard

Follow these steps to reinstall your MegaRAID SAS 9361 RAID controller in a PCIe slot on the motherboard.

1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is

grounded and has no AC power.

2. Install the RAID controller in a PCIe slot on the motherboard, as shown in the following figure.

NOTE This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.

Some PCIe slots, however, support only PCIe graphics cards; if a

controller is installed in one of these slots, the controller will not

function. Refer to the guide for your motherboard for information

about the PCIe slot.

3. Press down gently, but firmly, to seat the card correctly in the slot.

4. Secure the controller to the computer chassis with the bracket screw.

Figure 77 Reinstalling the RAID Controller

Press

Here

3_01658-04

Edge of

Motherboard

PCIe Slot

Bracket

Screw

Press

Here

CacheVault

Power Module 02

(CVPM02)

CacheVault

Flash Module 04

(CVFM04)

Remote Mount

Board

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 138 139

Pas de commentaire

Avago-technologies Cache Protection for RAID Controller Cards Manuel d'utilisateur Page 110