Avago-technologies Cache Protection for RAID Controller Cards Manuel d'utilisateur télécharger pdf (Page 107)

Avago Technologies

- 107 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide

May 2015

Chapter 2: Installing the Cache Backup Products

Attaching the CVFM04 Module to the RAID Controller and by Cable to a CVPM02 Module on

a Remote Mount Board

2.11.2.3 Installing the Clip on the Remote Mount Board

Follow these steps to attach the clip to a BBU-BRACKET-05 remote mount board.

1. With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the system

is grounded.

2. Remove the clip and the remote mount board module from the package.

3. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.

4. Hold the clip so the screw holes on the clip line up with the screw holes on the remote mount board, as shown in

the following figure.

Figure 74 Installing the Clip on the Remote Mount Board

5. Secure the clip to the CVPM02 module in three screw holes with the screws and the nuts.

6. The screws thread through the front of the clip and the remote mount board.

NOTE Center the screwdriver carefully to avoid stripping the screw heads.

Do not overtighten the screws.

Clip

3_00895b-00

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 138 139

Pas de commentaire

Avago-technologies Cache Protection for RAID Controller Cards Manuel d'utilisateur Page 107